C. Glamour ( India ) Company is Manufacturer, Exporter And Supplier Of Aluminium Pressure Die Casting Components, Ultrasonic Plastic Welding, Pressure Die Castings In Non Ferrous Metals Our Setup Situated in Ahmednagar, Maharashtra, India.
The track of roller should be absolutely clean and finished without any cold shuts and a back face is also to be finished as a belt rollesover and is successfully maintained.
Fins need to be free from cold shuts back face to be finished and no material folds and cold shuts permissible.
Fins need to be free from cold shuts of the back face to be finished and no material folds and cold shuts permissible.
The fins are deep arises a problem of a cold shut and blow hole. By proper settings, problem are eliminated.
The part the track of roller, should be absolutely clean and finished without any cold shuts and a back face is also to be finished as a belt rollesover and is successfully maintained.
This part is contineously having load and engaging and disengaging drives a big load. Blow hole which reduces strength are totally eliminated.
As a gearbox burs and any kind of foreign particales are not allowed. Even a die with a core flashes are maintained very low in cast condition only.
As a gearbox, burs and any kind of foreign particales are not allowed. Even a die with a core flashes are maintained very low in cast condition only. Specially used for wiper motors in four wheelers.
As stress is applied contineously, this part should be fully free from the porosity. Dimensional stabilty and blow holes are within control.
As stress is applied contineously, this part should be fully free from the porosity. Dimensional stabilty and blow holes are within control.
For Gear control mechanism. Extreme finish is required.
Area and depth are controlled within a limit. blow holes are not permitted and achieved successfully.
It is a safety part and extremely necessary to be free of blow holes.
Holding the levers of the vehicle and as is a front look of the vehicle finish and complete filling with absolutely low flashes are required. Achieved through proper operations and setting.
Safety is ensured as well as extreme finish is required.Perfect core alignment is required.
Safety is ensured as well as extreme finish is required.Perfect core alignment is required.
Operating Levers for Brakes and Cluteches. Dimensional Stability and Finish is required. Successfully producing with the required quality requirements.
As very precision spindles, after finishing even a single light blow hole is not allowed. Complete filling is achieved, blow holes are totally eliminated.
Area is large and even distribution is necessary without any blow holes as a safety item. Specially used in body building of luxuary buses.
As width is higher it gives restriction on being filled through out. Blowholes which may be the major factor is handled successfully. A very critical and important part of an automible. Any slight blow hole or porosity may rise problem. Area is greater and blow hole and porosity is eliminated and porosity at lower limits.